Heat Exchanger CRN Application Supplement Form 1437

AttachmentSize
heat_exchanger_crn_application_supplement_frm-1437-01.pdf201.36 KB
Embedded Scribd iPaper - Requires Javascript and Flash Player
British Columbia Safety Authority Engineering & Research, Operations Design Registration
Suite 200, 505 Sixth Street New Westminster, BC V3L 0E1
Phone: (778) 396-2027 Fax: (778) 396-2064 www.safetyauthority.ca 
 
Note: The information on this form is collected to administer the provisions of the BC Safety Standards Act and section 26 of the Freedom of Information and Protection of Privacy Act. If you have any questions about the collection, use, or disclosure of this information, contact the Records, Information and Privacy Analyst for the BC Safety Authority at 1-866-566-7233.
HEAT EXCHANGER CRN APPLICATION SUPPLEMENT
This supplement form is to be completed and signed for a heat exchanger reciprocal registration.
Drawing #:___________________________ CRN #: ______________________________ Revision: _________ Title: ___________________________
Date of Initial Registration: _____________________________
 
HEAT EXCHANGER TYPE (check one) IT Intercooler AF Aftercooler CT Coil Tube TE Shell & Tube CODE OR STANDARD OF DESIGN (check one) ASME Section I ASME Section IV ASME Section VIII, division 1 ASME Section VIII, division 2 ASME Section VIII, division 3 ASME PVHO-1 AE Aircooler PE Plate HX Non-Specific Heat Exchanger
ASME B31.1 ASME B31.3 ASME B31.5 CSA B51 CSA B52 Other (specify)______________________________
DESIGN AND SECTION DETAILS (complete and check applicable units) Heat Exchange Area: ___________________ m2 Overall vessel Length ___________________ ft Note: vessels with an overall length greater than 20ft (6.1 meters) must have detailed seismic and loading calculations submitted (see boiler and pressure vessel registration guide) Section Name: MAWP MAWT MDMT Diameter Length Section Name: MAWP MAWT MDMT Diameter Length Section Name: MAWP MAWT MDMT Diameter Length (eg. shell, tube, path) psig kPa deg F deg C deg F deg C inches feet inches feet (eg. shell, tube, path) psig kPa deg F deg C deg F deg C inches feet inches feet (eg. shell, tube, path) psig kPa deg F deg C deg F deg C inches feet inches feet
bar
mm mm
meters meters
bar
mm mm
meters meters
bar
mm mm
meters meters
RECIPROCAL COMPLIANCE DECLARATION I declare that the submitted design in this application conforms to the design that has been previously registered by another Province and that documentation of previous registration is provided.
  Name ______________________ Signature ___________________________ Date ________________________ 
FRM‐ 1437‐00 (2013‐02‐06)   
This document is © 2013 by JenniferLee - all rights reserved.